2. Measure and Trim the Locker
IMPORTANT! It is recommended the locker unit be cut using a circular saw and a fine toothed blade.
IMPORTANT! Do not cut the sides of the locker unit. Only trim the top or bottom to fit your wall length.
IMPORTANT! The locker unit must be placed with the shelf grooves angled upward. If the locker unit is
placed upside down the shelves will fall out.
Measure the vertical installation area to determine the cut dimensions for the locker unit.
Mark the cut lines on the back side of the locker unit.
NOTE: Remove any protective films on the locker unit surface before cutting.
Cut the locker unit to the required dimensions.
IMPORTANT! It is critical the locker unit is clean for a strong bond to be created by the adhesive.
Remove excess material and sand any rough edges using a sanding block.
Clean the back of the locker unit with denatured alcohol.
1248926-2-A 4 Kohler Co.
To Next Page
Loading...
Need help?
General
