4. Install the Locker Unit
IMPORTANT! The locker unit must be placed with the shelf grooves angled upward. If the locker unit is
placed upside down the shelves will fall out.
TIP: Urethane based adhesive may be more effective for locker unit adhesion.
Generously apply bath and shower construction adhesive to the back of the locker unit on the top,
bottom, and sides.
Position the locker unit into place at a slight angle.
Push the locker unit against the rough wall between the wood bracing. Press firmly and evenly
across the entire locker unit.
Wood
Blocking
1248926-2-A 6 Kohler Co.
To Next Page
Loading...
Need help?
General
