7. Surface-Mount - Secure the Cabinet
NOTE: The following instructions are for surface-mount only. For recess-mount installation, refer to the
″Recess-Mount″ sections.
Slide a clip onto each end of the top T-slot.
Center the cabinet on the wall as desired.
Using a 3/32″ drill bit, drill pilot holes into the wall.
If anchors are needed, remove the cabinet and install anchors into the wall at the pilot hole
locations.
Secure the clips with 1-1/2″ screws (provided).
Slide two clips onto the bottom T-slot.
Position each clip 2″ (51 mm) from the ends of the cabinet.
Using a 3/32″ drill bit, drill pilot holes into the wall.
If anchors are needed, remove the cabinet and install anchors into the wall at the pilot hole
locations.
Secure the clips with 1-1/2″ screws (provided).
3/32"
3/32"
2" (51 mm)
Kohler Co. 11 1337913-2-A
To Next Page
Loading...
