What to do if Kojair Platinum Laboratory Equipment control system alarms for low air flow velocity?
If the Kojair Laboratory Equipment control system alarms for low air flow velocity, you should check that grids on the workspace are not clogged. Also, ensure that a Bunsen burner is not used on the same side as the sensors inside the chamber (normally on the right side), as the flame can immediately trigger an alarm.
What to do if my Kojair Platinum alarm goes on, lights won’t go on and the fan is out of order?
If the alarm is activated, the lights won't turn on, and the fan isn't working on your Kojair Laboratory Equipment, verify that the power cable is properly connected both to the outlet and to the cabinet socket located on top of the cabinet. Also, check the user interface to ensure that the cabinet’s mode is set to normal.
What to do if Kojair Platinum outlet is currentless?
If the outlet of your Kojair Laboratory Equipment is currentless, check if the fault current has tripped; the switch is located on the electrical box under the front panel. If the outlet is an accessory, ensure that the current supply is connected with a separate cable to the outlet behind the cabinet, placed on the installation channel.
What to do if Kojair Laboratory Equipment control system alarms for low inflow air velocity?
If the Kojair Laboratory Equipment control system alarms for low inflow air velocity, verify that laboratory conditions meet the requirements. If the device is connected to an exhaust duct, confirm that the limit values set by the manufacturer correspond to the exhaust air values.
What to do if Kojair Platinum Laboratory Equipment alarm goes on but no failure is found?
If the alarm goes on for your Kojair Laboratory Equipment, but no failure is found, check that the front window is at the height of the work opening.
Why is the air flow velocity not stable in Kojair Laboratory Equipment?
To stabilize the airflow velocity in your Kojair Laboratory Equipment, ensure that cool air is not entering the cabinet through the front opening.
Measure airflow rates using calibrated anemometer or measuring device.
Test HEPA filters and seals for leaks using aerosol challenge.
Verify air curtain performance and retention with particle challenge.
Perform detailed inspection of cabinet exterior, interior, and functions.
Procedure for decontaminating the cabinet using H2O2.
Steps to replace LED light modules in the cabinet.
Instructions for replacing main and exhaust filters.
Procedure for changing the main circuit board and restoring the system.
Steps to update the core processor firmware using programming tools.
Procedure to update the display screen software (Biocontrol).
General| Category | Laboratory Equipment |
|---|---|
| Brand | Kojair |
| Material | Stainless steel |
| Series | Platinum |
| Application | Laboratory, pharmaceutical |
| Filter Type | HEPA |
To Next Page
