2019 Kolibri USAKB-062019
Cleaning Procedure
KCD-1000
Dirty sensors can affect the KCD-1000 performance and cause genuine bills to be rejected. It is suggested that
the user performs weekly maintenance on the unit to maintain top performance.
Items Needed
- Soft microfiber cloth
- Soft-bristled brush
- Can of compressed air
- Isopropyl alcohol
Steps
1. First, make sure the unit is turned off and unplugged
2. Perform the cleaning of each sensor, one step at a time (a to c), and check after each step if this
resolves the issue. If it does not, proceed to the next cleaning step
a. Wipe away dust with a soft microfiber cloth or a soft-bristled brush
b. Clean the sensors using a can of compressed air
c. Clean the sensors with a cotton swab lightly moistened with isopropyl alcohol – gently wipe
the sensors with the swab
Refer to the photos below showing the location of the KCD-1000 sensors. For each sensor, follow the steps as
described above.
Sensors Locations
Overview:
1. UV Sensor
2. IR Sensors
3. Magnetic Sensors
4. Start Sensor
2
3
4
1
To Next Page
General
