Kolin KCB-BLC-8859T - Installation and Setup; Unpacking and Component Identification; Faucet Assembly Installation

Installation and Usage Methods
WARNING
Do NOT use other liquids such as coffee, tea, juices, or beers in the water
source container. This unit is specifically designed for dispensing water only.
Do NOT use alternative containers. The water containers designed for this
dispenser are specifically intended for use with 3 and 5 gallons only.
Installation:
Remove the straps from the box, but avoid flipping it over or leaning it on its
side.
Open the box and remove the upper protective cover of the packaging.
Lift the carton box vertically.
Carefully remove the water faucet assembly, glass kettle, and black electric
kettle and any remaining components.
Take the water conveyance silica gels (small tubes) and insert them tightly
into the vertical post on the water outlet of the machine's table board. Ensure
that the tube with hot water markings is connected to the hot marking of the
water outlet on the machine's table board.
Also, connect the wire clip connector to its appropriate color (white and black)
for the electrical connection.
Align the water faucet assembly on the machine table with the screw holes
located at the back of the base of the machine.
5
•
•
•
•
•
•
•
1. Unpacking of the Coffee/Tea Bar Water Dispenser:
2. Installation of Water Faucet Assembly:
Wire Clip Connector
Silicon Tubes Connector
Back
Hot
Hot