Vers. 140323 rev
3. DESCRIPTION
1. Mounting holes
2. Display 4 digit / 8 lines
3. “ON/OFF” key : press for 3 seconds to switch tester on or off
4. “CLEAR” key : press to reset the displayed value
5. “UNIT” key : press to select the unit of torque measurements
6. Internal transducer or port for external transducer
4. MOUNTING
It is strongly recommended securing the tester through slots “1” to a workbench before operating.
Immobilizing the tester when checking torque values over 1 Nm is critical for the safety the operator as well
as for the accuracy of torque measurements during operation.
To Next Page
Loading...
