What to do if my Kolver EDU2AE Laboratory Equipment shows “Protection 14p5A”?
If the status bar displays “Protection 14p5A” on your Kolver Laboratory Equipment, the suggested solutions are: reduce the cycle rate and check the settings, avoid motor stalling, ensure unscrewing isn't too heavy, and verify the joint isn't too soft.
What to do if Kolver EDU2AE Laboratory Equipment displays “Error Torque Control”?
If “Error Torque Control” is displayed on the status bar of your Kolver Laboratory Equipment, create a new screw. If the error persists, change the torque and speed settings.
What does “OUTPUT DISABLED” mean on my Kolver EDU2AE and how can I fix it?
If your Kolver Laboratory Equipment displays “OUTPUT DISABLED”, it indicates the output signals protection has exceeded the maximum load (400mA). Check that the load does not exceed the maximum limit. To reset, restart the unit.
What to do if my Kolver EDU2AE displays “Error unscrew torque”?
If your Kolver Laboratory Equipment displays “Error unscrew torque”, avoid motor stalling and ensure that unscrewing is not too heavy, as the screwdriver couldn’t unscrew.
What does “Compensation error” mean on my Kolver EDU2AE Laboratory Equipment?
If your Kolver Laboratory Equipment displays “Compensation error” (the torque value is negative due to an excessively high negative compensation value), set a higher or lower compensation value.
Configure fastening parameters like model, ramp, torque, and speed.
Step-by-step guide to set torque levels and confirm calibration.
Explanations for error codes 3 through 15 and their solutions.
General| Brand | Kolver |
|---|---|
| Model | EDU2AE |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
