Kolver EDU2AE User Manual

Vers. 260918 3
Press any key on the front panel to enter the main screen (see following picture).
P
L
U
T
O
1
0
T
%
:
2
0
%
S
:
6
0
0
r
p
m
S
:
0
/
0
3
T
:
-
-
-
r
e
a
d
y
1- Screwdriver model
2- Pre-set torque level (percentage)
3- Selected speed
4- Screw count: fastened screws/total screws (model EDU 2AE/HP
RO
only)
5- Reached torque level (model EDU 2AE/HP
RO
only) in Nm, in.lbs or kgf.cm.
6- Status bar ( waiting, screwing, errors, etc…)
To enter the menu press ESC for 2 seconds.
Select the line by pressing or then press OK (the symbol 
will turn into ). Press or to select the required value and
then confirm through OK (or ESC if you don’t want to save the
value).
The selected value will be immediately operational, even if you
are still in the menu screen. Repeat these operations for all the
parameters you wish to set and then push ESC to return to the
main screen.
FRONT PANEL LED:
GREE LED: Screw OK.
YELLOW LED: Program End (only on EDU 2AE/HPro).
RED LED: error.
1
3
2
4
6
5

Kolver EDU2AE Specifications

General

Brand	Kolver
Model	EDU2AE
Category	Laboratory Equipment
Language	English