Vers. 140323 rev
Picture 11: Standard Report
-Complete set of values: it allows to export all the captured values (.xls file) and the graphics of
the results.
-Export current graphic: it allows to export any value in Graphic section of the Control Panel
(.pgn file). For the resolution of the image see SETTING chapter.
- Export last measure: it allows to export (.xls file) the set of data referring to the last measure
done. The table will show on X: time and on Y: torque value.
6. REPORT AREA
In this section, it will be displayed the statistics results of all the values including the instantaneous
data. In particular:
-Max value: max value of torque acquired
-Min value: min value of torque acquired (only in Track mode).
-Average value: average value of torque acquired (only in Track mode).
-Cm: value that indicates the machine capacity or process within the tolerance range.
-Cmk: value that indicates the machine capacity or process within the tolerance range of the nominal
torque value. A high Cmk indicated the the machine or the has a low dispersion, and is well centered
in the middle of the range of tolerance.
-Capacity: it indicates if the process f measurement is suitable or not.
Cm, Cmk ≥ 1.33 ➔ SUITABLE
Cm, Cmk < 1.33 ➔ NOT SUITABLE
There is the possibility to modify the index of tolerance to check the capacity
(default=1.33): in “SETTINGS”, set the desired value in “TOLERANCE
Cm,Cmk”.
-Nominal Torque (Cn): average torque value
-Max torque: Cn+Tolerance (Cn)%
-Min torque: Cn-Tolerance (Cn)%
- Sensor value: torque value given from the mini k.
-Current values: values referred to the last one acquired.
7. LANGUAGE
Four languages available: English, French, Spanish and Italian.
To change the language, in the menu push on Edit ➔Language.
8. SYSTEM REQUIREMENTS
It’s necesary to install the following software:
- Java (64-bit) (https://www.java.com/it/download/)
To Next Page
Loading...
