Vers. 140323 rev
The mode must be set on the minik/s: on the main screen flag or not the Track option.
However, Torque Analyzer has been designed to automatically align the receipt of the first measure
by detecting the capture mode set in mini k.
Picture 3: To flag Track mode.
4. DISPLAY AND SETUP
“Control Panel” area has 4 sections:
A. GRAPHIC: This section allows to display the graphics of the values (See picture 3).
There is also the possibility to zoom on specific areas.
Two types of visualizations:
1- ‘X-Y Plot’: temporal visualization of values.
2- ‘Bar Plot’: bar visualization of values.
Type of visualization can be set from the menu:
Edit ➔ Modify ➔ Chart.
B. TABLE: in this section all the values are displayed (max and min, average, date,..).
To Next Page
Loading...
