Vers. 140323 rev
2- GRAPHIC FEATURE
-Diamond pattern chart: in Track mode, it allows the visualization of points of
interpolation of captured values.
-X: width in pixels of the uploaded image.
-Y: height in pixels of the uploaded image
-Min value accepted: Min value captured and accepted by the software.
3- UNIT AND TOLERANCE
-Unit: it allows to choose between the following units of measurements: Nm, lbf.in and
kgf.cm
-Tolerance Ck, Cmk: it allows to set the tolerance to check the machine capacity.
It’s also possible to save the set up of the data tapping Save and keep the same setting for the
next sessions.
E. TORQUE TESTER: in this section it is allowed to enter all the data of the mini k.
To Next Page
Loading...
