Kolver mini K1/S User Manual

Vers. 140323 rev
5. JOINT SIMULATORS
The Joint Simulator (JS) consists of a screw compressing a series of washers enclosed in a case with hex
female head for proper fit to any Kolver torque tester. The head of the joint simulator can be supplied with
different attachment depending on the model used which allows the screwdriver to be connected to the joint
simulator.
Since a joint simulator cannot duplicate actual joints, the torque values displayed on the minik may vary
from the actual torque that a screwdriver will apply to the actual assembly.
Minik1 is supplied with a built-in joint simulator to increase low torque measurements accuracy.
Joint simulators available:
Code
Model
Screwdriver side
attachment
Torque tester side
attachment
Compatibile
torque tester
model
Included
with
240620
Hex13/M1,6
M1,6 Female thread
Female hex 13mm
MiniK1
K1
MINIKEF1
on request
240621
Hex13/M2
M2 Female thread
240622
Hex13/M3
M3 Female thread
240640
Hex13 – 1/4“
M4
Male hex 1/4“
Female hex 13mm
MiniK1
K1
MINIKEF1
MINIKEF1
240600
Hex13 – 1/4“
M6
Male hex 1/4“
Female hex 13mm
MiniK5
MINIKEF5
K5
MiniK5
MINIKEF5
K5
240800
Hex13 – 1/4“
M8
Male hex 1/4“
Female hex 13mm
Mini K20
MINIKEF20
K20
Mini K20
MINIKEF20
K20
240901
3/8” M12
Female Sq 3/8”
Male Sq 3/8”
MINIKEF50
MINIKEF50
240902
1/2” M12
Female Sq 1/2”
Male Sq 1/2”
MINIKEF100
MINIKEF100

Kolver mini K1/S Specifications

General

Brand	Kolver
Model	mini K1/S
Category	Laboratory Equipment
Language	English