5000 HOUR LUBRICATION AND MAINTENANCE CHECKS
NOTE: All 10, 100, 250, and 1000 hour service points
should be included with the following:
FRONT WHEELS -
Drain oil and check bearing preload as covered in
Section ‘‘G’’ of the Service Manual. Use Lube Key
‘‘C’’.
AIR CLEANER -
Clean the Donaclone Tubes in the pre-cleaner
section of the air filter. Use low pressure cold
water or low pressure air to clean tubes.
NOTE: Do not use a hot pressure washer or high
pressure air to clean tubes because pre-cleaner
tubes will distort.
STEERING CONTROL FILTER -
Change in-line filter at orbitrol steering control unit
inlet line.
RADIATOR -
Clean cooling system with a quality cleaning com-
pound. Flush with water. Refill system with anti-
freeze and water solution. Check Cooling System
Recommendation Chart for correct mixture.
Maintain cooling system according to engine
manufacturer’s recommendations.
NOTE: For additional or more specific information,
refer to service manual.
Truck Serial Number ____________________________
Site Unit Number ______________________________
Date:______________Hour Meter_________________
Serviceperson Name___________________________
COMMENTS √’d INITIALS
OM4005 10/96 Maintenance - Section 4
Lubrication and Service Page 4-11
To Next Page
Loading...
