8. Turbocharger (for 4TNE106T)
0.4
Disassembly Procedure
(1) Preparation for disassembly
In addition to the general tools, the following special tools are required for turbocharger disas-
sembly and reassembly:
Tool name
Bar
Use
For removing thrust bearing and thrust
bushing
Illustration
mm (in.)
Pliers
For removing floating bearing circlip
Material : Copper or brass
Pliers
For removing seal ring
rorque driver
For thrust bearing installation (for M3):
Item sold on market
or TORX bolt
13 kgf-cm (1.3N-m)
,multi-
For seal plate installation (for M3):
unctional type)
13 kgf-cm (1.3 N-m)
II
j to 50 kgf-cm
10.5 to 4.9N-m)
(Type : TORX TT20 or equivalent)
30x wrench For fixing turbine shaft
(10 mm x dodecagonal)
Box only may be used.
rorque wrench
For following bolts and nuts:
single
M8 : 13 mm, 285 kgf-cm (28 N-m)
+rpose)
M5 : 8 mm, 48 kgfcm (4.7 N-m)
M5 : 8 mm, 20 kgfcm (2.0 N-m)
Probe
For measuring play in axial and
To be installed on a dial gage
radial directions
05 (0.1968)
mm (in.)
(0.2755)
Mount to dii gauge
8-8
To Next Page
Loading...
