E-14
Recommended Parameter Setting
• Setting for soft work
If you want mild acceleration and deceleration or soft lifting and lowering speed in your materials handling operation to
prevent the load on the pallet from shifting or collapsing, this is the recommended parameter setting for your application.
Adjustment Item Initial Value Soft Message
Power Level (U/L/M/H) 2 0 0: U / 1: L / 2: M / 3: H
Custom (U): Travel Power 2 1 1: L / 2: M / 3: H
Custom (U): Acceleration Adjustment 6 1 1: Weak Acceleration / 8: Strong Acceleration
Accelerator Rate Property 2 3 1: Fast when half-operated / 2: Standard / 3: Slow
Plugging Regeneration Property Adjustment 60 20 0: Invalid / 100: Powerful
Brake Regeneration Adjustment 90 60 0: Invalid / 100: Powerful
Accelerator Neutral Regeneration Adjustment 30 20 0: Invalid / 100: Powerful
Custom (U): Material Handling Power 2 1 1: L / 2: M / 3: H
Custom (U): Lift Speed 100 70 Adjustable by every 10%
Custom (U): Tilt Speed 100 40 Adjustable by every 10%
ATT1 Speed 50 50 Adjustable by every 10%
ATT2 Speed 100 50 Adjustable by every 10%
ATT3 Speed 100 50 Adjustable by every 10%
Lifting Shock-less Level 3 1 Shock level is bigger with higher setting value.
Lowering Shock-less Level 3 1 Shock level is bigger with higher setting value.
*The above setting is available when pressing the [Soft] button on the easy setting.
• Setting for powerful work
Adjustment Item Initial Value Power Message
Power Level (U/L/M/H) 2 0 0: U / 1: L / 2: M / 3: H
Custom (U): Travel Power 2 3 1: L / 2: M / 3: H
Accelerator Rate Property 2 1 1: Fast when half-operated / 2: Standard / 3: Slow
Custom (U): Materials Handling Power 2 3 1: L / 2: M / 3: H
*The above setting is available when pressing the [Power] button on the easy setting.
To Next Page
