Komatsu D51PXi-24 User Manual

D51EXi -24
D51PXi -24
SERIAL NUMBER
D51EXi-24 - 10001 and up
D51PXi-24 - 10001 and up
BULLDOZER
Unsafe use of this machine may cause serious injury or
death. Operators and maintenance personnel must read
this manual before operating or maintaining this
machine. This manual should be kept inside the cab for
reference and periodically reviewed by all personnel who
will come into contact with the machine.
Operation &
Maintenance Manual
EENAM03570
WARNING
ORIGINAL INSTRUCTIONS

Komatsu D51PXi-24 Specifications

General

Brand	Komatsu
Model	D51PXi-24
Category	Construction Equipment
Language	English

Summary

READ THIS MANUAL

SAFETY INFORMATION

Safety Signal Words

Explains signal words (DANGER, WARNING, CAUTION, NOTICE, REMARK) used for safety messages.

SAFETY

General Precautions Common to Operation and Maintenance

General safety rules for operating and maintaining the machine.

Precautions When Getting On or Off Machine

Safety measures for mounting and dismounting the machine.

Precautions for Blade Automatic Control

Safety guidelines for operating the blade in automatic control mode.

PRECAUTIONS FOR OPERATION

PRECAUTIONS FOR MAINTENANCE

Precautions for Check and Maintenance

Safety measures during machine checks and maintenance procedures.

Precautions for GNSS Antenna

Safety advice regarding the GNSS antenna installation and handling.

OPERATION

EXPLANATION OF COMPONENTS

intelligent Machine Control SYSTEM

Explains the components of the intelligent Machine Control system.

CONTROL BOX

AUTO/MANUAL SWITCH

Describes the operation of the Auto/Manual switch for blade control.

When turning on the blade automatic control

When turning off the blade automatic control

CUT/FILL OFFSETS SWITCH

BACK GRADE MODE SWITCH

GNSS RECEIVER

MACHINE OPERATIONS AND CONTROLS

CHECKS AND ADJUSTMENT BEFORE STARTING ENGINE

Pre-operation checks and adjustments required before starting the engine.

OPERATIONS AND CHECKS AFTER STARTING ENGINE

Procedures for checks and operations after the engine has started.

RESET CYLINDER STROKE END

PREPARATIONS FOR BLADE AUTOMATIC CONTROL

Preparations required before activating the blade automatic control.

PREPARATIONS IN CONFORMITY TO EACH SITE CONDITION

Site-specific preparations needed before using automatic blade control.

SET BASE STATION

METHOD FOR CONFIGURING RADIOS

SPECIFICATIONS

SPECIFICATIONS: D51EXI-24

SPECIFICATIONS: D51PXI-24