.
MAINTENANCE
SERVICE PROCEDURE
LUBRICATION
1.
Using a grease pump, pump in grease through grease fittings marked by arrows.
2.
After greasing, wipe off any old grease that was pushed out.
Carry out the greasing operation every day when operating in places where the grease flows out easily, such as
when traveling through mud or water.
(1) Transmission front mount (1 place)
(2) Transmission rear mount (1 place)
(3) Center hinge pin (2 places)
(4) Praking brake (2 places)
4 - 72
To Next Page
