5.
T
ap “GNSS Configuration” button.
The screen changes to “GNSS Precision” screen.
6.
For the configuration setting of the radio device, it is not
necessary
to change the GNSS Precision. Tap “Next>”
button.
The screen changes to “GNSS Comms” setting screen.
REMARK
In this screen, you can set the threshold value of RMS val-
ue (error) which alerts “Low Precision” error.
You can input the value in accordance with the required
precision of the construction.
• “Max. GPS errors (roving)”: RMS threshold value used
when the machine is moving
• “Max. horz. RMS:”: Horizontal RMS threshold val-
ue
• “Max. Vert. RMS:”: Vertical RMS threshold value
• “Max. GPS errors (point measurement)”: RMS thresh-
old value used when the machine is stationary
• “Max. horz. RMS:”: Horizontal RMS threshold val-
ue
• “Max. Vert. RMS:”: Vertical RMS threshold value
7.
Connection information with GNSS antenna is displayed in
this screen.
If
you change the information on this screen, GNSS posi-
tioning becomes disabled. Tap “Next>” button without
changing any information.
The screen changes to the radio setting screen.
SETTING CONTROL BOX
7-147
To Next Page
Loading...
Need help?
General
