EG-3
PRECAUTIONS FOR SAFETY AND QUALITY
Correct Work
• Grasp the contents of each trouble, and then troubleshoot and
work efficiently.
• When removing and disassembling parts, check their normal
assembly condition in advance. Make match marks on places
which do not affect the function, if necessary.
• If an oil seal, gasket, packing, O-ring, lock washer, cotter pin,
self-lock nut, etc. are removed, replace them according to the
directions in their sections (Parts which must not be reused).
• When a tapered roller bearing or a needle roller bearing needs
to be replaced, replace its inner race and outer race as a set.
• Arrange the removed parts in order so that they will not be
mixed up.
• Before checking or assembling the disassembled parts, clean
them.
• When replacing a part, install a NISSAN genuine part.
• Use the specified oil, grease, sealant, etc.
• Before removing a pressurized pipe, hose, etc., release the
pressure.
• After repairing the fuel, oil, coolant, exhaust, or vacuum system,
check it for leakage securely.
Precautions for Radio Equipment Installation
Check the following when installing a commercial/ham radio or
mobile phone. If mounting position is not chosen carefully, the unit
may interfere with the electronic control system.
• Separate the antenna as far from the ECM as possible.
• Route an antenna feeder line at least 20 cm (7.87 in) apart from
the control unit harness.
• Adjust an antenna and feeder line to eliminate radio wave
interference.
To Next Page
Loading...
