.
OPERATION
TRANSPORTATION
TRANSPORTATION
When transporting the machine, observe all related laws and regulations, and be careful to assure safety.
TRANSPORTATION PROCEDURE
When transporting the machine, choose the optimum transportation method in reference to the weight and
dimensions shown in "SPECIFICATIONS (PAGE 5-2)". Note that machine specifications (weight and dimensions)
vary depending on the kind of tire and bucket.
LOADING, UNLOADING WORK WITH TRAILERS
WARNING
When loading or unloading the machine, run the engine at low speed, travel at low speed, and operate slowly.
When loading or unloading the machine, stop the trailer on firm level ground.
In addition, keep well away from the road shoulder.
Use ramps of ample width, length, thickness, and strength, and install them securely at an angle of less than 15°.
When using an embankment, compact the fill soil thoroughly and make sure that the slope face does not collapse.
Remove the mud stuck to the undercarriage to prevent the machine from slipping to the side on the ramps.
In addition, remove any water, snow, ice, grease, or oil from the ramps.
Never change direction on the ramps. There is danger that the machine may tip over.
If it is necessary to change direction, return to the ground surface or the trailer platform, correct the direction, and start again.
The position of the center of gravity of the machine will change suddenly at the connection of the ramp and trailer, and there
is danger of the machine losing its balance. Always drive slowly over this point.
When loading or unloading, always use ramps or a platform. Proceed as follows.
LOADING
1. Load and unload on firm level ground only.
Maintain a safe distance from the edge of a road.
2.
Apply the brakes on the trailer securely and insert blocks (1)
under the tires to hold the trailer in position.
Set the distance (3) between ramps (2) to match the distance
between the left and right tires, and make angle (4) of the
ramps a maximum of 15°.
If ramps (2) sag appreciably under the weight of the machine,
put wooden block (5) under the ramps to support them.
3. Determine the direction of the ramp, then slowly load the
machine.
4.
Load the machine correctly in the specified position on the
trailer.
3 - 142
To Next Page
Loading...
Need help?
General
