OPERATION OPERATION
3-86
STOPPING ENGINE 0.
NOTICE
If the engine is abruptly stopped before it has cooled
down, engine life may be greatly shortened. Conse-
quently, do not abruptly stop the engine apart from an
emergency.
In particular, if the engine has overheated, do not abruptly
stop it but run it at medium speed to allow it to cool gradu-
ally, then stop it.
1. Run the engine at low idling for about 5 minutes to cool
down gradually.
2. Turn the key of starting switch (1) to the OFF position to
stop the engine.
3. Remove the key from starting switch (1).
CHECK AFTER STOPPING ENGINE 0.
1. Walk around the machine and check the work equipment, body work, and undercarriage, and check also for
leakage of oil and water.
2. Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4. Remove any mud affixed to the undercarriage.
To Next Page
Loading...
Need help?
General
