Komfovent Domekt R 150 F User Manual

44 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

DOMEKT

C8 AUTOMATION

INSTALLATION MANUAL

Table of Contents

Questions and Answers:

M
Matthew WilliamsonAug 17, 2025
How to fix low supply air flow in my Komfovent Fan?
- T
  Tammy PetersAug 17, 2025
  If you're experiencing low supply air flow with your Komfovent Fan, here are a few things to check: * Make sure your air filters aren't dirty. If they are, replace them. * Check for any obstructions in your air ducts, dampers, or inlet/exhaust openings. * If you're using VAV air flow control, ensure the pressure sensors are properly connected. If VAV isn't needed, switch to CAV or DCV in the settings. * If the above doesn't resolve the issue, the supply air fan may not be working, and you should contact authorised service.
R
Ronald MillerAug 20, 2025
How to troubleshoot low extract air flow in my Komfovent Fan?
- E
  Elizabeth PerezAug 20, 2025
  If you're experiencing low extract air flow with your Komfovent Fan, here are a few things to check: * Make sure your air filters aren't dirty. If they are, replace them. * Check for any obstructions in your air ducts, dampers, or inlet/exhaust openings. * If you're using VAV air flow control, ensure the pressure sensors are properly connected. If VAV isn't needed, switch to CAV or DCV in the settings. * If the above doesn't resolve the issue, the extract air fan may not be working, and you should contact authorised service.
D
Dennis HoltAug 26, 2025
Why is the return water temperature low in my Komfovent Fan?
- R
  Rebekah ArcherAug 26, 2025
  If you are experiencing a low return water temperature in your Komfovent Fan, consider the following: * Verify that there is hot water in the water heater system. * Check if the circulation pump is working correctly. * Ensure the water control valve is opening properly. * Confirm that the return water temperature sensor is correctly installed as per the installation manual. If issues persist, contact your installer or authorized service.
J
Jacqueline McdonaldAug 28, 2025
How to fix a heat exchanger failure in my Komfovent Fan?
- A
  Ashley KnightAug 28, 2025
  If you are experiencing a heat exchanger failure in your Komfovent Fan, here are some things to check: * For DOMEKT R devices, check for any obstructions preventing the rotor heat exchanger from rotating and inspect the rotor belt for tears. * For DOMEKT CF units, if the air bypass damper of the counter-flow heat exchanger is malfunctioning, contact authorised service.
D
deckerericAug 31, 2025
Why is the supply air temperature low in my Komfovent Fan?
- B
  Brandon FergusonAug 31, 2025
  If the supply air temperature from your Komfovent Fan is too low, it could be due to: * Integrated heaters not working: Contact authorised service. * Additional heating/cooling devices faulty or incorrectly installed: Contact the company that installed or sold the equipment. * Faulty air temperature sensor: Contact authorised service.
S
Sharon GutierrezSep 2, 2025
What causes high supply air temperature in Komfovent Fan?
- D
  David OliverSep 2, 2025
  If the supply air temperature from your Komfovent Fan is too high, it could be due to: * Integrated heaters malfunctioning: Contact authorised service. * Additional heating/cooling devices malfunctioning or incorrectly installed: Contact the company that installed or sold the equipment. * Faulty air temperature sensor: Contact authorised service.
A
Amanda FarmerSep 5, 2025
Why is the heat exchanger icing up in my Komfovent Fan?
- J
  Jennifer WalshSep 5, 2025
  If your Komfovent Fan's heat exchanger is icing up, it could be due to: * Malfunctioning antifreeze protection: Check the antifreeze protection settings and ensure any external pre-heater being used is working correctly. * Antifreeze protection switched off: Verify the antifreeze protection settings. If you're not using an integrated or external pre-heater, you can't use a device with a counter-flow heat exchanger when the outside temperature drops below -4 °C.
P
Paul WardSep 8, 2025
What causes low heat exchanger efficiency in Komfovent Fan?
- E
  Edward ArmstrongSep 8, 2025
  If a message indicates low heat exchanger efficiency in your Komfovent Fan, here are some potential causes and solutions: * If air is being extracted through an additional branch (only for DOMEKT R devices), and that's not needed, close the fifth branch. Ensure any air closing damper in the auxiliary extraction duct is completely closed. * If the supply air volume significantly exceeds the extract air volume and this difference isn't required, unify the air flow settings. * If the unit door isn't fully closed, leading to mixed air flows, ensure the door is firmly pressed shut and that the gaskets aren't worn.
H
Holly MooreSep 12, 2025
What triggers an internal fire alarm in my Komfovent Fan?
- J
  Jeffrey PageSep 12, 2025
  If your Komfovent Fan is showing an internal fire alarm, it may be triggered because: * The internal air temperature is above 50°C: Locate the heat source in the ductwork or unit. * Faulty temperature sensor: Contact authorised service.
K
Kevin BooneSep 14, 2025
What to do, if my Komfovent Fan indicates clogged air filters?
- F
  foleymichaelSep 14, 2025
  If your Komfovent Fan indicates clogged air filters, switch off the device and replace the air filters. After replacement, delete the message.

Komfovent Domekt R 150 F Specifications

General

Airflow	150 m³/h
Heat recovery efficiency	Up to 90%
Power voltage	230 V
Phase	1
Frequency	50 Hz
Maximum power consumption	120 W
Filter class	F7

Related product manuals

Komfovent DOMEKT R 250 F C6

Komfovent DOMEKT R 400 V

Komfovent DOMEKT R 300 V

Komfovent DOMEKT R 450 V

Komfovent DOMEKT R 400 H

Komfovent DOMEKT R 500 V

Komfovent DOMEKT R 700 V

Komfovent DOMEKT R 600 H

Preview: Komfovent Domekt REGO

Komfovent Domekt REGO

Preview: Komfovent DOMEKT series

Komfovent DOMEKT series

Komfovent VERSO R 1300 F

Komfovent VERSO R 2000 F