Valve Adjustment
Follow us on
The valve can be adjusted to your application refer to guide
below:
The valve MUST be in the OFF position for the Levelsmart to
control it. This means it should always be in the OFF position
unless you want to manually fill your pool
The Flow control knob is important if you are filling a smaller
body of water.Turn this down halfway or more when using on
a spa. For pools, leave it all the way open.
To manually put water in your pool or spa, turn the solenoid
knob counter clockwise ¼ turn. * Make sure you shut it back
into the OFF position after doing so.
If the valve is left in ON position it will over fill your pool.
Always make sure it lives in the OFF position.
The valve can be installed in any orientation successfully
without harming performance.
.
1
2
3
4
5
A
B
C
D
Solenoid Knob
Keep this in the “OFF” position.
Turn “ON” to allow water in
manually if desired
Flow Control Knob
For pools leave all the way
open. For smaller bodies of
water (spas and ponds)
tighten down atleast halfway
Bleeder Knob
Leave as is.
Arrow
Make sure water flow is the
same directionas arrow
indicates
A
B
C
D
LevelSmart User Manual
To Previous Page
Loading...