Change desired water level
Quick Start for LevelSmart installation:
BEFORE BEGINNING BRING WATER TO DESIRED LEVEL
For more detailed instructions visit www.KonaLabs.com/Pages/Help
Follow us on
Valve controller LED Guide
Alarm
Action
Sensor
LevelSmart User Manual
Follow us on
Interacting with the Magnet Switch
The magnet will not “magnetize” to the controller or
the sensor. You have to hold it in place.
The red “ALARM” Led will flash back at you when the
magnet switch is activated on the controller. When-
ever using the magnet you want to see the ALARM
LED illuminated when the magnet is applied to the
valve controller.
The remote sensor will let you know it has been
engaged with three green lights upon removal of the
magnet. There will only be 3 flashes.
If you place the magnet on the valve controller and
can not get the “ALARM” LED to illuminate, move the
magnetaround that area until you get the red ALARM
LED to illuminate indicating you are engaging the
magnet switch. In some instances, the polarity is
slightly off, but is not broken.
Make sure your valve controller is showing a green
sensor LED.
Bring water to new desired water level, making sure
it is still on the sensor.
Use the magnet to reset the sensor in the pool by
holding the magnet on the sensor for 5 seconds and
removing it
Make sure you got three green flashes on the sensor
when you removed the magnet
Now observe the valve controller green sensor LED
flash for about a minute as it re calibrates your new
set level.
Make sure you end with a solid green sensor LED.
Alarm, Action and Sensor all flashing in a sequence
This represents the Valve controller is in pairing mode,
and looking for a sensor to pair with. This is the most
default mode of the valve controller and it will continue to
cycle until A sensor is engaged and starts sending
signals out. To get into this mode, you can hold the
magnet on the valve controller for 15 seconds or longer
and remove it, this will put it into pairing mode.
Action LED flashing
This represents the LevelSmart is going through the
pairing process. This will happen immediately after you
engage the sensor. This pairing process lasts 2.5
minutes. The first 30 flashes are 1 second apart, and the
next 2 minutes of flashes are 4 seconds apart. Once
successful pairing is completed, the valve controller will
show a solid green “SENSOR” LED.
Sensor LED
This represents the LevelSmart is going through the pairing
process. This will happen immediately after you engage the
sensor.
Sensor and Action LED
This represents the LevelSmart is in working order and
paired up, and the valve is open putting water into your
pool or spa. Whenever you have the ACTION LED on
with the green sensor LED, this means the valve is OPEN
and putting water into your pool.
Sensor and Alarm LED
This represents the sensor is paired and paired success-
fully, and the magnet is on the valve controller and
engaging the magnet switch. You will see this whenever
you are using the magnet. If you do not see this, move the
magnet around the magnets sweet spot until you get the
red ALARM LED indicating it sees the magnet. This is
used during a reset, or a valve check
Each illuminated LED can represent different things, so it is
important to understand what each LED represents.
Sometimes you will have two LEDs illuminated at the same
time. Below is the key to identify each LED on the valve-
controller and what it means.
The magnet is the tool we use to interact with the
LevelSmart. In the event you want to pair, reset or
change a desired set level, you will need the magnet to
do so.
Things to know about the Magnetic Switch:
1
2
3
4
5
6
To Next Page
Need help?
General