EN - 11
• Insert the appliance into the aperture.
2.2. Electrical Connection and Safety
WARNING: The electrical connection
of this appliance should be carried out
by an authorised service person or
qualified electrician, according to the
instructions in this guide and in compliance
with the current local regulations.
WARNING: THE APPLIANCE MUST
BE EARTHED.
• Before carrying out the connection to
the power supply, the voltage rating
of the appliance (stamped on the
appliance identification plate) must be
checked for correspondence to the
available mains supply voltage, and the
mains electric wiring should be capable
of handling the appliance’s power rating
(also indicated on the identification
plate).
• During installation, please ensure
that isolated cables are used. An
incorrect connection might damage
your appliance. If the mains cable is
damaged and needs to be replaced
this should be done by a qualified
personnel.
• Do not use adaptors, multiple sockets
and/or extension leads.
• The supply cord should be kept away
from hot parts of appliance and must not
be bent or compressed. Otherwise the
cord may be damaged, causing a short
circuit.
• If the appliance is not connected to the
mains with a plug, a multi-pole isolator
switch (with at least 3 mm contact
spacing) must be used in order to meet
the safety regulations.
• The fused switch must be easily
accessible once the appliance has been
installed.
• Ensure all connections are adequately
tightened.
• Fix the supply cable in the cable clamp
and then close the cover.
• The terminal box connection is placed
on the terminal box.
1
1
L1
PE
PE
N
N
L2
L3
2
2
3
3
4
4
To Next Page
Loading...
