EN - 13
4. USE OF PRODUCT
Control of Hob
The appliance is operated by touching
buttons and the functions are confirmed by
displays and audible sounds.
1
2
3 4
5
6 7
8
9
10
11
12
13
14
15
1- Heater display
2- Activate/Deactivate heater
3- Activate/Deactivate timer
4- Timer display
5- Timer function cooking zone indicators
6- Triple zone indicator
7- Dual zone indicator
8- Stop/Go
9- Dual/Triple zone selection
10- Decimal point
11- Heat setting/Timer sliding buttons
12- Heat setting/Timer sliding indicator
13- Key lock indicator
14- Key lock
15- On/Off
Mode Descriptions
Stand-By-
Mode
S-Mode The mains is applied to the
hob control and all heater
displays are off or a residual
heat display is active.
Operating-
Mode
B-Mode At least one heater display
shows a heat setting
between ´0` and ´9`.
Lock Mode VR-
Mode
The hob control is locked.
Turn on and Turn off the Appliance
If the appliance is in Stand-By mode, it
is put in Operating mode by pressing the
On/Off button
for at least 1 second.
A buzzer sound indicates the successful
operation.
On all heaters a ´0` will appear and all
decimal points for the heaters will flash (1
sec on, 1 sec off).
If there is no operation within 10 sec, the
display on all heaters will turn off.
If the displays are turned off, the heater will
be sent into Stand-By mode.
If
is pressed more than 2 sec (in
Operating-Mode), the appliance is switched
off and is set into the S-Mode again. The
appliance can be turned off by pressing
at any time; even if other buttons are
pressed simultaneously.
If there is any residual heat from a heater,
this will be indicated in the corresponding
Heater Display.
Select Heater
If a single heater is chosen with the
corresponding Activate/Deactivate Heater
Button
, the Decimal Point of the Heater
Display flashes. For the selected heater,
you can set the heat level between 1-9 by
touching the Heat Setting Slider Button
.
The slider button must be pressed within
3 sec, otherwise the heater selection is
cleared and heat setting dot will disappear
(Decimal Point). If there is no further
operation within 10 seconds, the heater
falls back into the S-Mode.
The heat setting can always be changed
by pressing
between
levels 1-9.
Each slider button operation or each display
change is accompanied by a buzzer sound.
Turn on Dual and Triple Zones
Turn on the dual zone
The activation of the dual zone is carried
out after selecting the desired heater by
pressing
. This is confirmed by a buzzer
sound. At the same time, the corresponding
Dual Zone Indicator illuminates. Touching
for a second time, toggles the status of the
dual zone; it changes from dual zone on to
dual zone off and back again.
The extension zone can only be activated
after a level between 1-9 is set on the basic
zone of the heater.
Turn on triple zone
A dual or triple zone can only be switched
on, if the basic zone of a heater is set to
a level between 1–9 and the heater is
selected (the dot is illuminated).
If
is pressed, the buzzer sounds and
the Dual Zone Indicator is illuminated. If
is pressed again, there is another audible
signal and the triple heater is switched on.
The Triple Zone Indicator will be illuminated
To Next Page
Loading...
