What to do if my Kongsberg Monitor fails to display any data?
If your Kongsberg Monitor fails to display any data, first ensure that all connections to the unit are correctly established. Also, verify that the data source supports either the J1939 or J1587 message protocol.
Why are active alarm messages not displayed on my Kongsberg KAntrak Monitor?
If active alarm messages are not displayed on your Kongsberg Monitor, make sure that the data source provides alarm message data in the J1939 Active Diagnostic Trouble Codes- Diagnostic Message 1 (DM1) format.
How to troubleshoot a Kongsberg Monitor that does not power up?
If your Kongsberg Monitor does not power up, check to ensure that all connections to the unit are correctly and securely connected. Also, verify that a power source is present and functioning correctly.
What to do if stored alarm messages are not displayed on Kongsberg Monitor?
If stored alarm messages are not displayed on your Kongsberg Monitor, verify that the data source provides alarm message data in the J1939 Active Diagnostic Trouble Codes- Diagnostic Message 2 (DM2) format.
How to fix a blank display on a Kongsberg Monitor?
If the display on your Kongsberg Monitor is blank or black, try adjusting or resetting the lighting and contrast settings. Also, ensure that the ambient temperature is within the operating range specified for the unit.
Why does my Kongsberg KAntrak bleep at start-up and not store settings?
If your Kongsberg Engine Monitor bleeps at start-up and does not store settings, it means the unit has failed its self-test. In this case, contact your Engine Monitor supplier for assistance.
What to do if Kongsberg KAntrak fails to display certain parameters?
If your Kongsberg Monitor fails to display certain parameters or you are unable to select specific parameters, verify that the Engine Monitor supports the required parameters. Additionally, ensure that the data source provides these required parameters.
Allows users to set various operating parameters like units, language, and display settings.
To Next Page
General