Kongskilde K 20 C - User Manual

38 pages

Go to English

Save Page as PDF

To Next Page

K 20/30/40 C

& KAI 25 C

Brugsanvisning

Gebrauchsanweisung

Directions for use

Instructions de service

Istruzioni per l'uso

Gebruiksaanwijzing

Libro de instrucciones

Bruksanvisning

Main Page

Questions and Answers

K
kriceAug 11, 2025
How to troubleshoot a Kongskilde Farm Equipment motor that does not start?
- G
  gomezdanielleAug 11, 2025
  If the Kongskilde Farm Equipment motor doesn't start, the issue might stem from several causes. First, check the power line and voltage, and replace the fuse if necessary. A faulty or damaged power cord could also be the culprit, so inspect and replace it if needed. Additionally, the motor or capacitor may be faulty, requiring a check and potential replacement. Overheating can also cause a lock-out; if this occurs, shut down the appliance, check the air inlet and outlet, wait a few minutes, and then restart it. If problems persist, apply to the Professional Technical Service.
K
kristinamoralesAug 23, 2025
What to do if Kongskilde K 20 C motor runs but the heater does not ignite?
- E
  ehowardAug 23, 2025
  If the Kongskilde Farm Equipment motor runs, but the heater fails to ignite and subsequently locks out, consider these potential causes and solutions: * The fuel tank may be empty or contain dirty or wrong fuel. Remove the incorrect fuel and replenish with clean Diesel or Paraffin. * A clogged fuel filter could be restricting fuel flow. Clean or replace the fuel filter. * Leaks in the fuel line might be present. Check the pipes, tighten connections, and replace if necessary. * The burner nozzle could be clogged. Clean the nozzle by blowing compressed air, or replace it if needed. * Low temperatures may have increased the diesel viscosity. Mix Diesel with 10-20% Paraffin.