app.
Notes:
The address is only accessible when WiFi or USB is connected to the PrinCube
network.
If the Android system cannot access the address normally, please turn off the
automatic network switching function, and ignore or select ‘No’ when popping up
the notification of using the mobile network.
Please use the QR code scanning tool that does not rely on the Internet, or enter
the address manually.
This APP is tested on Chrome, Safari and Firefox.
1. Turn on the power switch on the bottom of the printer and wait for 5 seconds to
get ready to go with a beep.
2. Place the printer on the test paper and press the button for 1 second to
automatically clean the nozzle. It may take several times to ensure that the entire
3 colored lines are ejected.
3. Place the printer on the surface of the object to be printed.
4. Click the button, the green indicator light is on, and it’s ready to print.
5. Slide the printer to the direction you want to complete the print operation. The
green light goes off when it’s finished.
Notes:
If the nozzle is dirty, please push out the brush in the base to clean the nozzle;
If the nozzle is particularly dry, please pour a little water on the table, remove the
cartridge, and soak the nozzle in water for about 1 minute.
1. Click ‘New’ to create a new file.
2. Click ‘Add image’ or ‘Add text’ to add content.
3. Click on the image or text to move, rotate and zoom. (Click the selected text
again to re-edit the content.)
4. After the material is added, click ‘Print Preview’ to enter the Crop mode.
Print Operation
App Operation
To Next Page
Loading...