For special features press the application key and select the desired function.
BASIC BOOK COPYING:
This feature is utilized when making copies out of a book.
1. From the default copy screen, press the application key.
2. Press book copy.
3. From this screen, make sure full scan is highlighted.
4. Ok the selection, and make sure non image area erase and auto layout are
highlighted along with book copy. (non image area erase eliminates the
black toner background commonly associated with copying from books,
and auto layout will center the image on the page). Ok these selections to
go back to the main copy screen.
5. Open the copier lid (RADF unit), place the book on the platen glass and
press start. Leave the lid open! (notice that the copier will not make the
copies yet. It is storing the information it scans into its memory).
6. After the scan lamp is finished scanning, you may flip to another page and
repeat step 5 (for as many pages needed out of the book).
7. When finished scanning all desired pages, take the store key off, and press
the start button. The copies requested will come out in consecutive order.
BASIC BOOKLET:
This feature is utilized for making booklets.
1. From the default copy screen, press the application key.
2. Press booklet.
3. Leave left binding highlighted.
4. Ok the selections at this screen, then ok the selections again at the
application screen in order to go back to the main copy screen.
5. Load the originals in the document feeder in the order in which you read
them (cover first, page 1, page2, page 3…)
6. Press start.
7. Fold the copies in half.
(note: to make a newsletter, after step 5 select a paper tray with 11 x 17 size
paper, and continue with the instructions above).
To Next Page
Loading...
