Mounting
To mount the wall holder, proceed as follows:
1.) Unpack and check product for damage and completeness
Technical data
Material
Bracket: Steel, powder-coated black
Support: Plastic, black
Dimensions/Support (W) 60 x (D) 121 x (H) 67 mm / 60 x 100 mm
Packaging (W) 60 x (D) 121 x (H) 60 mm
Weight 0.125 kg
The headphone wall holder is pre-assembled.
Accessories bag: 2x screws, 2x dowels
Headphone wall holder
Both holes of the wall bracket must be
used for fastening. A suitable fastener must
be selected according to the wall condition.
Align the wall holder on the wall and mark
the two drill holes. Drill the holes according
to the selected fastener and screw the wall
holder tightly to the wall. Make sure that the
opening of the wall holder is facing up-
wards.
2.) Install headphone wall holder.
To Next Page
Loading...
Need help?
General
