17620 Guitar Stand »Double«
- ideally secures headstocks using support arms and is ideally suited for uncommon and asymmetrical instrument forms
- also suited for guitars and base guitars of differing lengths
- protects instruments thanks to: a. rubberized headstock support arms
- b. thick foam cushioning for the body of the instrument.
- The support arms are effective and easy to use:
- - the support arms move independently of each other and adjust perfectly to all
--common guitars with headstocks
- - lobes at the end of the support arms protect the instrument from shifting
- - the guitar is easy to hang on the support arms, due to the fact that both support arms automatically
--remain in the open position once the instrument has been taken from the stand
- collapsible, i.e. very transport friendly
- easy to use, easy to setup and operate
- tools are not required for assembly
SAFETY NOTES
- Be sure that the surface is suitable, sturdy and level
- Maximum stability is given when the base struts of the stand are level (refer to 3).
- The fact that the product is collapsible and adjustable, can result in the risk of pinching/wedging,
- careful and attentive handling during setup, operation, and disassembly is indispensable.
- The support arms are suitable for almost all headstocks.
- Due to the large range of guitar models - exceptions - can - however exist.
- A pre-check is indispensable (refer to F)
- The instrument must always be placed into the support arms with due care.
- Please ensure that the guitar is in the proper position - that the support arms and the
- cushioning are in the correct positions.
- The protective covers on the support arms are made of high quality rubberized plastic
- and to the extent technically possible free of softening agents. An independent institute
- tested the product and found that chemical reactions with the, in part, very sensitive
- guitar coatings were not identified.
- Mechanical wear and tear, i.e. scratches or marks in the guitar coating depend on the coating quality.
- In particular, solvent-containing coatings that contain nitrocellulose are relatively soft, any resulting
- marks from the supports are purely a result of gravity.
- Please consider:
- A guitar is there to be played and over the course of time it will show typical signs of usage.
- Other objects than guitars are not permitted (e.g. clothing).
- Only suitable for indoor use
SETUP INSTRUCTIONS
TECHNICAL DATA
Thank you for choosing this product. This instruction manual informs you about the important
steps to set up and handle the product. We recommend to keep the manual in a separate place
for a possible later use.
Material
Tubes, sheet metal parts, screws - Steel, black
Handles, guides - Polyamid (PA), black
End caps, support arm cushioning - TPE, black
Cushioning - PU-Foam material, gray
Dimensions
Setup height: 1150 - 1350 mm
Base diameter / Required space ø 760 mm
Packaging
Box
Weight
2.1 kg
A. DIMENSIONS
B. SETUP THE STAND
The stand is setup without needing tools and is easy
to setup. It is pre-assembled and only has to be
put in position.
1 Loosen the clamp screw a bit,
2 Expand the legs until...
3 ...the connecting struts are level.
4 Re-tighten the lower clamping screw.
4 NOTE:
4 Manual strength is enough; Over-tightening can negatively
4 affect the components and should be avoided.
Disassembly is performed in the reverse order.
A. DIMENSIONS
B. SETUP THE STAND
To Next Page
Loading...
Need help?
General
