SAFETY NOTES
SETUP INSTRUCTIONS
1.
Remove »HELI 2« from the box.
2.
It is best to grab the lower tubes (both
arms) and open them by pulling them apart.
- When they are in the correct position you
- will hear a click.
3.
Both struts can be locked into place in four
positions.
- Place the pegs of the left strut into the slots
- on the right strut - they are in the correct
- position when they click into place.
4.
Disassembly is performed in the reverse
order.
- Pick up both struts and click the left strut
- into place using your thumb.
Thank you for choosing this product.
The instructions provide directions to all of the important set up and handling steps.
We recommend you keep these instructions for future reference.
- Be sure that the surface will bear the load and is suitable and level.
- Carefully set or lean the instrument on the upper rubberized rest
- Collapsing the product or adjusting the width bears the risk of pinching fingers; being careful and attentive during setup, operation,
- disassembly is indispensable
- Several tests of independent institutes have confirmed that the rubber used in this product is of the highest quality and the rubberized
- surface is a neutral barrier between the stand and the instrument's surface, i.e. the rubber does not corrode the surface of the
- instrument. Please note, however, that some surfaces (particularly nitrocellulose) are relatively soft and just placing an instrument on
- the stand can leave marks. This is not due to a chemical reaction, it is however, a result of gravity.
- Now collapse both arms back together
17581 E-Guitar Stand
»Heli 2«
- The proven and newly revised E-Guitar Classic
- The entire surface touching the instrument is rubberized providing
- optimal instrument protection
- With new innovative width adjustment
- Robust and durable metal construction
- Compact and collapsible with a very small and extremely flat footprint
- Unsurpassed simple handling; tools not required
To Next Page
Loading...
Need help?
General
Weight and Dimensions
