Konig & Meyer Saxxy User Manual

Es-Alt / Tenor Saxophonständer 14340/14350/14355 »Saxxy«
Eb-Alto / Tenor Saxophone Stand, 14340/14350/14355 »Saxxy«
zusammenlegbar - für den Transport im Schalltrichter
folds up for transport in the bell of the saxophone
»Saxxy« aus dem Velourbeutel
entnehmen.
Take »Saxxy« out of its velour pouch.
Mittlere Stange um ca. 15 mm aus
Gewinde herausdrehen.
Unscrew the rod in the center
approx. 15 mm out of the thread.
Mittlere Stange nach unten drücken. (Die vier
äußeren Stangen werden kurz angehoben
und fallen dann in die richtige Position = 4a).
Push the rod in the center down. (The four
outer rods will lift for a moment and then fall
into the correct position = 4a).
K&M-Schraubenkopf gegen die vier
Stangenenden drücken und mittlere Stange
wieder festschrauben.
Press the K&M screw head against the four
rod ends and then screw tight the rod in the
center.
Vier außenliegende Stangen nach
außen wegklappen.
Fold out the four outer rods.
1
34
4a
5
2
ca. 15 mm

Konig & Meyer Saxxy Specifications

General

Brand	Konig & Meyer
Model	Saxxy
Category	Racks & Stands
Language	English

Summary

Saxophone Stand Assembly Instructions

Remove Stand from Pouch

Take the saxophone stand out of its protective velour pouch.

Extend Outer Support Rods

Fold out the four outer support rods of the stand.

Adjust Center Rod Height

Unscrew the center rod by approximately 15 mm from its thread.

Engage Locking Mechanism

Push the center rod down to lock the outer rods into position.

Secure Center Rod

Press the screw head against rod ends and tighten the center rod.

Saxophone Placement and Important Notes

Mount Saxophone on Stand

Hang the saxophone bell between the upper rods, using rubber rings for cushioning.

Adjust Support Cord and Rings

Position the rubber cord and supports to contact the instrument's reinforcement ring.

Floor Protection Advisory

Use non-sliding pads under rubber feet to prevent marks on sensitive floors.