To Next PageTo Next PageWhat to do if my Konig TV Tuner has no signal or a weak signal?
If you are experiencing no signal or a weak signal, inspect the cable connections, LNB, and any other equipment between the LNB and the receiver. Also, ensure that the dish is properly aligned.
What to do if my Konig TV Tuner has no sound or picture but the front panel shows red light?
If there's no sound or picture, but the front panel displays a red light, the receiver is likely in standby mode. Press the standby button to take it out of standby.
What to do if Konig TV Tuner RCU is not working?
If the RCU is not working, make sure you are aiming the RCU at the receiver, and that there is nothing blocking the front panel.
Manage TV and radio channels, and delete channels by satellite.
Configure antenna connection, setup, and perform satellite searches.
Adjust language, time, parental lock, display settings, and system information.
Access conditional access, network settings, upgrades, and RSS reader.
Play built-in games like Othello and Sudoku, and manage media playback.
Manage PVR storage, settings, and safely remove USB devices.
Guide for searching channels on a single satellite.
Instructions for resetting the receiver to factory default settings.
Procedure for upgrading the receiver's software via USB.
Critical safety warnings for operating the device safely.
Instructions for cleaning and caring for the receiver.
Details regarding the product warranty and limitations.
Notes on designs, trademarks, and manual liability.
General