Kontax Tensegrity - Secure Assembly Plate to Arms

Fit the slot in the assembly plate over the lower arm and
screw 1x assembly screw through the arm into the assembly
plate.
You should be able to screw it in using your fingers, but if not
you can use a small cross-point screwdriver. Do not tighten
too much or you risk marking the arm.
Fit the second arm into the slot in the assembly
plate and screw 1x assembly screw through the
arm into the assembly plate.
Tensegrity cable grub screws assembly instructions page 5 of 14
Copyright Kontax Engineering Ltd 9/1/23