Kontax Tensegrity User Manual (English)

To Next Page

These instructions are for the centre cable with grub screws version of the Tensegrity table.

Please read all the way through the assembly instructions to familiarise yourself with the process

before you start and pay close attention to the alignment of all the parts in the diagrams.

Assembly time should be approximately 15-20 minutes.

Tensegrity cable grub screws assembly instructions page 1 of 14

Other manuals for Kontax Tensegrity

Need help?

Do you have a question about the Kontax Tensegrity and is the answer not in the manual?

General

Secure adhesive rubber feet to the designated dimples on the bottom of the base for stability.

Attach the two support arms to the base using countersunk screws, ensuring proper alignment.

Fit the assembly plate over the arms and secure each arm with an assembly screw.

Fit the centre cable into the arm slots and secure with grub screws, ensuring a flush fit.

Position and screw the top plate onto the arms, verifying correct orientation by screw fitment.

Loop outer cables into top plate slots and secure with grub screws from the underside.

Fit shuttles into base slots and secure with roundhead screws, attaching each shuttle.

Feed outer cables through the base, loop around shuttle screws, take up slack, and tighten shuttle screws.

Adjust cable tension for stability, avoid over-tightening, and note load capacity limits.