Identify the top surface of the top plate,
this is the side with the countersinks on the
two holes.
Position the top plate over the arm with
the top surface upwards and screw 2x
countersunk screws through the top plate
into the arm and tighten.
If the plate is the right way up the screws
should fit slightly below the surface. If the
plate is the wrong way up the screws will sit
above the surface, in which case the plate
will need reversing.
Countersinks
Tensegrity cable grub screws assembly instructions page 7 of 14
Copyright Kontax Engineering Ltd 9/1/23
To Next Page
Loading...
