Kooper 5907450 - Operation and Usage Instructions; Starting the Appliance; Temperature Setting and Indicators; Defrosting Procedure

 
6. Never splash water onto the appliance otherwise the insulation of the electric parts will be
impaired and speeding the rusting and corrosion of the metal parts.
7. If there occurs the leakage of gas pipes, or liquefied petroleum gas, you must exhaust the
inflammable gases around the appliance. Never pull out the power plug from the socket or switch
o the thermostat otherwise there is the possibility of explosive ignited by the electric spark thus
caused.
8. Never touch the inner wall of the appliance with your wet hand otherwise your hand will be
frostbitten.
9. Put the appliance key beyond the reach of the children to prevent them locking themselves in
the freezer.
10. Never store combustible, volatilizable or explosive goods.
OPERATION INSTRUCTION:
A. Start the appliance:
• When running the appliance for the first time,
please set the thermostat knob to the proper
position, then, turn on the power.
• After that, the compressor will continuously run
a few hours to reach the set temperature. When
the temperature drops to the set level,
compressor will automatically and alternatively
run or stop.
B. Temperature setting:
• The appliance is functioning as freezer and the
temperature inside the appliance decreases
gradually from Level min to 7;
• Position between “7” and “max” is set for fast
freezing. We suggest set knob back to Level 1-7
after the foods inside the appliance reach the
desired temperature in order to save resource
and protect compressor.
C. Indicator lights:
• The light “POWER” indicates that the electricity
power is connected;
• The light “RUN” indicates that the compressor is
running. This light should be alternatively o and
on when the knob is set to Level min-7. And
should be continuously on when the knob is set
between “7” and “max”.
DEFROSTING
The moisture in the food and air can frost the surface of the evaporator in the lower temperature and
the frost layer will aect cooling result. It’s necessary to remove the frost in time when the thickness
of the frost layer is 7mm.
1. Before defrosting, regulate the thermostat to the quick-freezing
position and make the temperature of the frozen food further lowered better for storage.
2. Turn o the power, empty all frozen food stus and take eective measures to reduce the
dissipation of cooling capacity.