WARNING
- Read before application and keep the introductions cautiously.
- In order to make freezer and commercial freezer work eectively and also for your convenience
and safe use, please read the user’s instruction and the attached leaflet before using and keep them
for later reference.
PACKAGING AND TRANSPORTATION
– When unpacking for checking, you must remember all the positions of packing parts, after that,
you must repackage the freezer strictly as the original packing.
– When handling and transporting the appliance, you should avoid the bumping and violent
vibration, and the dip angel of the appliance must be over 45° otherwise it will damage the cooling
system.
INSTALLATION
1. 1. You must take away the inflammable packing base before use, which is good for the heat
release of lower condenser and also convenient for the move.
2. The freezer should be placed on the level, solid floor to make the compressor work properly and
reducing the vibration and noise, also for the safety of use.
3. It should not be installed close to the heat sources or under the sunshine otherwise it will
increase the power consumption and reduce the life time of the plastic parts and the surface
coating.
4. The appliance should be put in a dry place. If it is put in the humid place for a long time, moisture
will cause the appliance body rusty and aect the electric insulation.
5. In order to make the appliance release the heat quickly and well ventilating, there should be
enough space around the appliance. The appliance with flat-back condenser should be placed in
position with a space of about 100mm all around. The side of the machine room of the appliance
with circulating condenser should be left enough space (about 100mm) at the front and back vent
so as to make the air flow freely and low power consumption
SAFETY INSTRUCTION:
1. Attention to the power requirement of the rating plate. Too high or too low of the voltage will
cause damage to the compressor.
2. You must use the socket with the properly electric meter and fuse. Do not share the socket with
other appliance.
3. There should be a good ground connecting on the socket. When using the appliance outdoors,
much more attention should be paid on the grounding connecting. Grounding wire cannot connect
with the gas pipe, heat-radiator, water pipe, telephone line grounding wire and lightning rod or the
single-phase power zero line. If in the humid place, an extra leakage current protection switch
should be installed.
4. Correctly connect and disconnect the plug. When insert the plug, it must be plugged tightly.
When pulling out the plug, you should hold the plug by hand. Do not pull the power cord with hand
so as not to loosen or break the wire inside the plug.
5. Do not damage the power cord insulation. Never press the power cord heavily and you are not
allowed to change and lengthen the power cord.
To Next Page
Loading...