Kooper Cosmo - Page 26

26
Without obstacles
ahead, the machine
often makes wrong
turns
1.Dust in the universal
wheel
2.Dirt in anti-fall sen-
sor
1.Remove the univer-
sal wheel, open the
cover board and cle-
an the dust.
2.Clean the anti-fall
sensor with a soft
cloth or tissue
The machine often
goes back and forth
on the same spot
Some object under
the bottom of machi-
ne
Check if it’s an even
floor and if there is any
object under the bot-
tom of the machine
The machine fal-
ls from height or
upstairs
Malfunction of the an-
ti-fall sensor
Clean the anti-fall
sensor with a soft
cloth or tissue, con-
tact qualified person-
nel if the problem per-
sists.
The robot often stops
under the bed
1.Lack of light under
the bed
2.Dirt on light sensor
1. Open the window
or turn on the light
2.Clean the light sen-
sor
The side brush does
not work
The side brush is en-
tangled by hair
Take off the brush
and remove the hairs
Dustbin cannot be
closed
Button doesn’t pop
out after pressing it
Remove the screws
on the dustbin cover,
take off the button
cover, clean it and
reinstall.