Remove the top cover and pour clean cold water into the water tray.
Water will drain
down through this
hole into the
water tank
Pour Water in
Here Only
• The water will drain down through the small hole into the water tank inside.
• Fill until the water level has reached the Maximum mark on the indicator which is located on the
lower front of the unit.
DO NOT OVERFILL. UNPLUG THE WIRE DURING THE AMOUNT OF LIQUIDS OPERATIONS.
Ice blocks can also be added which will help cool the water / air.
Place ice in the rear Ice Channel as shown. Do not add water to this area. Ice can also be added to
the Water Filling Tray.
in the target area, place
only ice cubes and do
not add water.
• Do Not Fill with any liquid other than clean cold water. Do Not add any additives to the water.
• Refit the Cover before turning on.
To Next Page
Loading...
