Kooper Triofresh - Page 31

 
OPERATION
ON/OFF
• Insert the power plug into an power point and switch on. The On/O indictor light will illuminate.
• Press the “ON/OFF” button on the control panel (or remote con-trol). The unit will start in the default
“Low” Speed as indicated by the indicator light and Normal Mode, or to the pre-programmed
memory setting.
Note: Only the fan will be running at this time. To Turn O, press the “ON/OFF” button again.
Mode
Press the “Mode” button to select between, “Normal”, “Natural” and “Sleep” fan wind patterns.
a. Normal: The “Normal” mode is just a constant wind speed and will only vary speed if the speed is
manually adjusted with the “Speed” button.
b. Sleep: The “Sleep” variable speed wind allows you to set the product so that the wind speed will
decrease gradually from a high speed to low (starting from the fan speed selected by the user).
The variable speed wind speed will simulate the flow of an evening breeze slowing to a light variable
speed night breeze.
c. Natural: The “Natural” variable speed wind mode automatically selects one of three variable speed
wind speed patterns. Each Pattern produces a dierent wind pattern depending on the Speed
Setting Selected.
These Wind Patterns simulate the variable speed wind that you would experience outdoors.
Speed
• By default, when the unit is turned “ON”, it starts at “High” speed.
• Each press of the “SPEED” button advances the Speed setting as indicted by the lights above the
“SPEED” button. Continue to press the button to cycle around.
• Press the “ON/OFF” button to turn the appliance o.
Auto O Timer
• Use this power-saving feature if you want the appliance to turn o automatically.
• To select the O time, press the “TIMER” button once. It will advance to 0.5h as indicated by the
indicator lights above the “TIMER” button.
The cooler will turn o after approximately 0.5 hours
Each consecutive press will advance the timer at 0.5h increments until it reaches a maximum time
of 7.5h.
The time set will be indicated by the sum of the lights which are illuminated. i.e. if the 0.5h + 2h + 4h
lights are illuminated, this adds up to be 6.5 hours. The cooler will turn o after approximately 6.5
hours
• To turn the timer o, or to reset to a new time, continue to press the “TIMER” button until is
cycles back around where no time lights are illuminated.