• Press the “ON/OFF” button to turn the appliance o.
Cool
• Press the “COOL” button if you want to have cooler wind blowing from the air cooler. (refer to
section “Guide to Evaporative Coolers) This activates the cooling water mechanism inside the
appliance causing the air to be cooler. The Indicator light above the button will be illuminated when
this feature is On.
• Press the “COOL” button again to turn this function o.
• Press the “ON/OFF” button to turn the appliance o.
Swing
• Press this button if you want the vertical louvers to swing from left to right.
• Press it again to stop the vertical louvers from swinging.
Note: The Horizontal Louvers can be manually adjusted to direct the air higher or lower.
Varying Wind Speed
Refer to the section “Speed”.
CARE AND CLEANING
ON/OFF
• Turn o and unplug the unit prior to cleaning.
• Remove any water which is left in the water tank. Take the ap-pliance outside and remove the
rubber drain plug in the rear of the unit. Water will pour out from the bottom of the appliance. Re-
place the drain plug when empty.
• Be careful not to tip or knock the appliance over.
• Clean the air cooler regularly especially the rear air inlet filter. Do not allow this filter to become
blocked.
The filter be cleaned by using a vacuum cleaner hose with a brush attachment. Ensure the mesh is
dry before vacuuming. Alternatively, the mesh can be removed for washing. To do this, push the two
clips down and then pull the mesh out.
Wash using a soft damp cloth or rag and mild detergent for wipe dry.