the code.
Step 3: Operations of the speed button of remote control. Push the pole forward to speed up
the skateboard while pull it to brake. To switch, press the direction switch button. It means
the skateboard moving direction is changed when the red direction switch indicator light is
on.
Step 4: The battery level indicator has four grids, representing 100%, 75%, 50% and 20% of
battery respectively. When there is only one grid, it means the skateboard is in low battery
level and needs charging or replacement of batteries.
3.2 Charging method:
3.2.1 Please use the supporting adaptor in case of charging and insert the DC plug
directly into the battery charging port. The red light will be on during charging and the green
light will be on after it is fully charged.
3.2.2 The battery should be fully charged once monthly if it is not used for a long time.
Step 5: Electric Skateboard 10 minutes does not use will automatically shut down.
IV. Notice on Safety Use
1. Please pay attention to the safety notices when you’re going uphill or downhill, climbing
stair, or meeting barriers, as shown in the figure:
2. The electric skateboard should be used in a safe place rather than on road or in any
insecure places.
3. Make sure to use safety products like sports shoes, safety helmet, wrist support, etc.
4. Please do not use at night with poor sight.
5. Please make sure every screw and nut is in good condition before use.
6. Please change wheels after using for a long time so as to prevent brake failure due to
worn wheels.
To Next Page
Loading...