koppel ERA series - Table of Contents; Safety Precautions; Preparation before Use

CONTENTS
Safety Precautions........................................................................1
Identification of Parts...................................................................2
Remote Controller........................................................................4
Operation Instructions..................................................................6
Maintenance.... ............................................................................8
Protection.....................................................................................9
Troubleshooting...........................................................................10
Installation Instructions................................................................11
Preparation Before Use
Remote Controller Presetting
Before using the air conditioner, be sure to check and preset the following:
Each time the remote Controller gets a new set of batteries or is energized,
.
Press any button when the flashes and
If you don t press any button within 10 seconds, the remote controller is preset to automatically.
the symbol will flash from
COOL and HEAT alternatively
COOL symbol COOL mode will be set.
' COOL mode
Auto-restart Presetting(optional):
The appliance is preset as Auto-restart function by the manufacturer.If Auto-restart function is not needed, follow the
steps below to cancel this function:
1) Make sure the air-con's power is off.
2) Press and hold the emergency button (on/off) on the indoor unit.
3) Keep pressing the Emergency button for more than 10 seconds until four short beeps are heard.
Then Auto-restart function is disabled. To activate the Auto-restart function, repeat above procedure until three
short beeps are heard.