Korg KONTROL49 - Page 5

Table of Contents
v
Quick-assign for control changes............................................. 23
[2] SLIDER (Slider assignment) ..................................................24
[3] PAD 1–8 (PAD 1–8 assignment) ..........................................24
[4] PAD 9–16 (PAD 9–16 assignment) ......................................26
[5] Pitch Bend (Pitch Bend assignment)......................................26
Assigning a single MIDI message to the full range
(up/down)................................................................................... 26
Assigning separate MIDI messages to the up/down
ranges ........................................................................................... 28
■ Assigning aftertouch.......................................................... 29
■ Assigning velocity .............................................................. 29
■ Assigning a control change............................................... 30
[6] MOD (MOD Wheel assignment) ..........................................30
[7] VECTOR-X (Vector-X assignment) ........................................31
[8] VECTOR-Y (Vector-Y assignment).........................................32
[9] SW1/SW2 (SW1/SW2 assignment)....................................32
Using the switches in one-parameter mode ........................... 32
Using the switches in two-parameter mode........................... 33
[10] PEDAL (Pedal assignment).................................................35
■ Assigning a control change................................................... 36
[11] FOOT SW (Foot SW assignment) .......................................36
■ Assigning a control change................................................... 37
[12] KEYBOARD (Keyboard setting)..........................................38
[13] MAIN ENC (Main Encoder assignment)..............................40
■ Assigning Program Change and Bank Select..................... 40
[14] MESSAGE (Message setting)..............................................41
■ CtrlChg (Control Change message).....................................42
■ ProgChg (Program Change message) .................................42
■ BankSel (Bank Select message)............................................. 43
■ Free Mesg (Free message) .....................................................43
[15] USB-MIDI PORT (USB-MIDI Port setting)..............................44
About the KONTROL49 and the driver ports........................45
MIDI IN devices......................................................................46
MIDI OUT devices..................................................................46
About the KONTROL49’s MIDI connectors...........................46
When not connected via USB................................................ 46
When connected via USB.......................................................46
[16] GLOBAL (Global setting) ...................................................46
■ Pedal Polarity setting ............................................................. 47
■ Pedal Calibration setting .......................................................47
■ LCD Backlight setting............................................................48
■ Pad Illumination setting ........................................................48
Message mode ..........................................................49
[1] PANIC (Panic message).......................................................49
[2] SNAP (Snapshot message)..................................................50
[3] NOTE OFF (All Note Off message).......................................50
[4] GM ON (GM On message)..................................................50
[5] STOP (Stop message)..........................................................50
[6] START (Start message) ........................................................51
[7] CONTINUE (Continue message)...........................................51
[8] TAP (Tap tempo message)...................................................51
[9]–[16] USER MESG 1–8 (User message)..................................51
Scene mode...............................................................52
About the OCTAVE SHIFT/CURSOR keys, [ENTER] key, and [EXIT]
key.........................................................................................52
[1]–[12] Select Scene ...............................................................52
[13] MIDI Channel ...................................................................53
[14] DUMP..............................................................................53