What to do if my Korg Sound on Sound does not power on?
If your unit isn't powering on, first ensure the batteries are inserted with the correct polarities (+, -). If that's not the issue, the batteries may be exhausted, or the AC adapter might not be connected correctly. Please check both of these possible causes.
Why is there no input sound on my Korg Recording Equipment?
If you're not getting any input sound, several things could be the issue. First, ensure the input level is correctly set. Confirm that the recorder is in either Record Ready mode or Record mode. Check that all devices are properly connected. If using a Plug-In-Power compatible microphone, verify the P-IN-PWER parameter is set to ON. Also, make sure the volume level of any connected external devices is appropriately adjusted. Ensure the REC parameter in the RHYTHM category is not set to ON, and that the MIX BAL parameter is properly configured. Finally, check that the VOLUME parameter isn't set to “0.”
Why does my Korg Sound on Sound turn off unexpectedly?
If your Korg Recording Equipment is turning off unexpectedly, it might be due to the Auto Power Off parameter being set to one of the minute options. Check this setting to resolve the issue.
Why can't I record with my Korg Sound on Sound?
If you're unable to record, make sure the input level is correctly set. Verify that a memory card is inserted. If a card is present, ensure it has sufficient free space. Check that the REC parameter in the RHYTHM category is not set to ON, and confirm that the MIX BAL parameter is properly configured.
Why is there no playback sound heard on my Korg Recording Equipment?
If you are not getting any playback sound, the volume level may be set to “0.” Please, check the volume level.
What to do if my Korg Sound on Sound Recording Equipment recorder is not responsive to button operation?
If your recorder isn't responding to button presses, the Hold mode may be turned on. Please check if the Hold mode is active.
Why is the LCD display dark on my Korg Sound on Sound?
If the LCD display is dark, the backlight may have been set to turn off. Check your backlight settings.
Why is input or recorded sound not what I expect on my Korg Sound on Sound?
If the input or recorded sound isn't what you expect, make sure that the input level (LEVEL parameter) is adjusted correctly. Also, the tone of the input sound may have been adjusted (TONE parameter).
Why is no sound emitted from the internal speaker of my Korg Sound on Sound?
If no sound is coming from the internal speaker, it's likely that the sound from the internal speaker is muted because headphones are connected to the recorder or the internal microphone input is enabled. Disconnect headphones or disable the internal microphone to restore sound to the speaker.
What does it mean if recorded sound is interrupted on my Korg Sound on Sound Recording Equipment?
Recorded sound may be interrupted if the recorder was exposed to an impact during recording, or if the batteries were exhausted during recording.
Discusses environmental factors affecting unit performance and power connection guidelines.
Guidelines for safe handling, cleaning, and avoiding foreign matter.
Step-by-step guide for battery installation and life.
Step-by-step guide for memory card installation.
Lists compatible card types and formatting instructions.
Procedures for powering the unit on and off.
Identifies and describes various input/output jacks on the unit.
How to connect and select guitars, microphones, or line devices.
Steps to create and start recording a new song file.
Detailed guide to perform overdubbing.
Step-by-step guide for using the built-in tuner.
Explains settings for input level, low cut, and tone.
Details MIC GAIN, N-GATE, and P-IN-PWR settings.
Details on adjusting effect parameters and their application point.
Instructions for formatting memory cards for the first time.
Instructions for downloading and installing system updates.
Calibrates the touch slider for accurate response.
Initializes the recorder to factory default settings.
Lists and explains various error messages.
Lists and explains more error messages.
Solutions for unit not powering on or dark LCD.
Troubleshooting button, slider, and sound problems.
Addresses issues with input level, tone, and noise.
Solutions for cannot record, interrupted sound, and unit not starting.
General| Sampling Frequency | 44.1 kHz |
|---|---|
| Bit Depth | 16-bit |
| Recording Format | WAV |
| Recording Time | Up to 6 hours |
| Storage Media | SD card (up to 32GB) |
| Power Supply | 4 AA batteries |
| Effects | Reverb |
To Next Page
