Korg Sound on Sound - Troubleshooting: Input and Recording; Input Sound Problems; Recording and Unit Start Issues

53
•Makesurethattheinputlevel(LEVELparameter)isadjustedcorrectly
(seepage29).
•Thetoneoftheinputsoundmayhavebeenadjusted(TONEparame‐
ter)(seepage29).
No input sound is heard.
•Makesuretheinputlevelissetcorrectly(seepage29).
•IstherecorderinRecordReadymodeorRecordmode?
•Makesu
rethat
alldevicesareconnectedcorrectly(seepage14).
•Ifyouareus ingaPlug‐In‐Powercompatiblemicrophone,settheP‐IN‐
PWERparametertoON(seepage30).
•Makesurethatthevolumeleveloftheconnectedexternaldeviceisset
correctly.
•TheRECparameterintheRHYTHMcategoryma
yhav
ebeensetto
ON(seepage34).
•MakesurethattheMIXBALparameterissetproperly(seepage32).
•TheVOLUMEparametermayhavebeensetto“0”(seepage43).
Cannot record.
•Makesurethattheinputlevelissetcorrectly(seepage29).
• Haveyouinsertedamemorycard?
•Thememo
rycardma
ynothavesufficientfreespace(seepage38).
•TheRECparameterintheRHYTHMcategorymayhavebeensetto
ON(seepage34).
•MakesurethattheMIXBALparameterissetproperly(seepage32).
Recorded sound is interrupted.
•Therecorderwasexposedtoanimpactduringrecording.
•Thebatteriesma
yhav
ebeenexhaustedduringrecording.
The unit does not start properly.
•Thecontentsofthememorycardmaybeincorrect.
•Theunitwasunabletorecognizethememorycard.
Inthiscase,turnonthepowertotherecorderwhilepressingandhold‐
ingdowntheRecordbuttonandtheMENUbuttonsimultaneouslyto
forcetheunittofo
rmattheinstalledmemorycard
.Iftheunitstilldoes
notstartcorrectlyafteryouformatthememorycard,thememorycard
ortherecordermaybedamaged.Tryusinganothermemorycardand
restartingtheunit.Iftheproblempersists,consulttheKorgdealer
fromwhomyoupurchasedtheunit.
Fo
rmattinga
memorycardwillerasealldataonthecard.